1、Post-swimming water washing：About the electrophoresis processing line without UF water washing, it is necessary to replace the post-electrophoresis water washing in time to prevent the dry paint stains and the appearance of secondary flow marks.

2, off the line: on the line with short leaching time, it is recommended to add compressed air blowing at this station to prevent the workpiece from entering the baking channel and forming water stains. For the paint film appearance of higher requirements of the line, in this station can be added to the artificial spray washing, and then leaching or blowing water.

3, drying: now commonly used heating air circulation method for convection method. The continuous production line mostly uses bridge-type drying channel, and the intermittent production line mostly uses channel-type, and even some small electrophoresis processing plants have a big drying oven. The heating source is coal, natural gas, diesel, electricity, etc., and mostly use the form of downward air supply and upward air extraction, the hot air must be filtered, and the combustion chamber (furnace chamber) should be separated from the baking channel to prevent bringing in soot particles. In daily production, we need to pay attention to the cleanliness of the baking channel to prevent the occurrence of particles or soot dripping oil shrinkage and other drawbacks; it is necessary to fully clean up regularly to prevent the risk of fire.

4, black electrophoresis processing sewage treatment: electrophoresis processing sewage discharge is large, advocating the need for supporting sewage treatment equipment, do not discharge sewage directly.